black-electronics.com
\# Fuse atmega8 high byte HFUSE: # 0xc9 = 1 1 0 0 1 0 0 1 <-- BOOTRST (boot reset vector at 0x0000) # ^ ^ ^ ^ ^ ^ ^------ BOOTSZ0 # | | | | | +-------- BOOTSZ1 # | | | …
On the quest to make my own oscilloscope and logic analyser using KST Planning to make a gui that will read the serial port and log the data to file that will be read by …
This is a nice little nifty circuit that has a power jack, 7805 regulator ,two capacitors and connector. It send the input power to upper rails and 5v to lower rails, …
I always wanted to make a clock, I have many instrustables bookmarks I finally settled on one, the binary, built on arduino, and not special rtc, just good ol’ …
I first AVR programmer was a usb, I got in my 4sem of under grad, I knew nothing about uCs I knew what can be done using these, could not program on my own so I took the …
I had to talk on skype, Requirments Internet : check Skype installed : check Speakers : check Mic : not available Luckly I had few electret microphone laying around and a …
General keyboard shortcuts Ctrl + A = Select all Ctrl + C = Copy the highlighted content to clipboard Ctrl + V = Paste the clipboard content Ctrl + N = New (Create a new …
Operating Principles for Inductive Proximity Sensors Inductive proximity sensors are used for non-contact detection of metallic objects. Their operating principle is …
Extremely useful for prototyping small circuits, get the PDF here.
I found out how to do this recently and thought it might be helpful to some people. To output this information to a file in your home directory you would use, Code: dpkg …
