Open Source PCB ruler - Update 2
Finally I received the rulers, they are still panellized, I’ve asked a hardware store to get me a tool to cut it which will put a v-grove on the pcb, I used a hack saw on one of then, didn’t turn out to well. I found some issues with it, the biggest was I used a small font for the foot prints and some other small issues, so back to eagle and fix all of them and make a v1.0 release.
Here are the rulers arrived from seeed.
Comments:
spilkos -
Hi,r u sell this pcb ruler?
#### [hemalchevli]( "[email protected]") -
There are some minor issues in these, I’ll rectify it and order new PCBs, you can buy those new ones.
#### [spilkos]( "[email protected]") -
thanks for your reply Hemal, that pcb ruler is two or one piece…cause on your photo I see two same pcb, is that correct?
#### [hemalchevli]( "[email protected]") -
:) its one piece, the picture was took when I just received it in mail. I panelized so its cheaper to manufacture, it also has five 5v switching regulator circuit on right side which is not a part of the pcb ruler..
#### [spilkos]( "[email protected]") -
thanks, when are you be ready to sell a piece me? I mean that when you known the price including shipping to Greece. ..
#### [hemalchevli]( "[email protected]") -
I’ll drop you a mail when I get the new PCBs, the price will be around $4-5 with shipping
#### [spilkos]( "[email protected]") -
thanks Hemal, I’m waiting for your reply thru email… Kostas..
#### [spilkos]( "[email protected]") -
hi Hemal r u receive the pcb?
#### [spilkos]( "[email protected]") -
Hi, any news from pcb yet?
#### [Hemal Chevli]( "[email protected]") -
I’ll send it for production tomorrow I should get in it after 2 weeks.
#### [hemalchevli]( "[email protected]") -
Hello, I have received the new and imporoved PCBs, send me your address on hemal(at)black-electronics(dot)com
#### [spilkos]( "[email protected]") -
ok Hemal I send you the address.With your reply tell me the cost for one pcb including shipping to Greece. Kostas..
Archives
Tags